Inpropack Torna- Jet 929

 Automatic machine for streching pallet make Inpropack, model Torna-jet 929 EBR. 2 Units available.

Automatic installation for baling all kinds of grouped or stored on pallet loads. Automatic wrapper is made after the pooled pallet load or static position "standing pallet" upward-downward spiral have positioned for system "rotating coil" feeder and automatic pre-stretch (optional) and synchronized with the rotational speed of the film coil and the up-down coil holding frame. Once the wrapping cycle is complete, the pallet goes to the storage area or load fully programmed by the electrical box with PLC command.

The advanced design of the machine Girospack EBR 929 is optimal for wrapping pallets with unstable loads.

The baling system with "standing pallet" allows us to go to higher cadences than conventional turntable machines to completely eliminate the centrifugal force on the load placed on the pallet.

The welding assembly, cutting assembly mooring or plastic frame, allows us welding and cutting the plastic being automatically prepared for him next pallet.

Key features:

1. Longitudinal and transverse stringers below to provide your perfect stability.

2. Fours adjustable columns that serve machine frame, supporting lift systems, rotation and wrapping.

3.  Trolley-reel holders. Descends and ascends forming a spiral around the load can be preset turns at the top and bottom area of the pallet, prepared especially for 300 mm diameter rolls. It is mounted on the rotational arm.

4 . Rotational arm. It consists of a bracket supported on a longitudinal which remains in the center by a geared motor and gear system at the same time to avoid the lever action column that carries frame guides built wheels rub on a bow, placed in the upper structure machine.

5 .Rotational Motor. Gear motor with electronic variable periods, with acceleration and deceleration, to affect a soft start and stop are roughly. It is mounted on the top of the machine, provided with a rough toothed arm for transmission.

. 6 Electric power collectors for heel holpers column carriage and devices; of highly conductive material, provided with nine tracks completely isolated from the rest of the structure.

7. Electric brushes that feed the coil car with special floating device and highly abrasion-resistant material.

8. Swing Collet and drag movie in boot time and instant automatic threading. It is mounted in tandem welding thereof.

9. Welding jaws and mesh film, that once the completed pallet wrapping effect a welding of the plastic layers being perfectly welded plastic end. Electronic control for temperature controllers.

10. Cutting System film or mesh for temperature controlled electronically. Accompanying the welding jaw so that the cutting cycle is synchronized to the welding and plastic tie clip.

11. Movie clips swing moored in drag.

12. Photocells which detects the entry of the pallet and accurately determine the height of the baling plastic thereon, regardless of the different measurements of the pallets; is set automatically.

13. Motorcycles lift truck reel holder located in the same rotational arm. Allows raising and lowering the carriage reel holder.

14. Electric panel command of the machine through PLC and frequency converters, commands manually or fully automatic all machine movements.

General specifications.

Overall dimensions of the pallet: 1,000 x 1,200 x 2,200 mm

Paletizable Maximum height: 2,200 m

Paletizable minimum height 500 mm

Merchandise maximum weight: 3.000 kg

Production pallets / hour: 50 - 100 units (depending on format)

Current connection; 380 / 220V. 50Hz (three phase AC)

Operating voltage: 24V. AC

Power Consumption: 6.5 - 8.5 kw / hour

Air consumption: 25 liters / minute

 Air Pressure: 3-5 Bar